Aqua Mix Ultra-Solv 3.8 Litres Tile & Grout Sealer

Aqua Mix Ultra-Solv®

Ultra-Solv® is a premium grade, high performance solvent based penetrating / impregnating sealer for all interior & exterior natural stone (including around salt water swimming pools), tile & grout surfaces. Formulated to provide maximum stain protection, especially in food preparation and serving areas. This premium sealer also includes built in Microban® – Cured Sealant is Mould & Mildew Resistant. Perfect for very dense stone and tile such as porcelain and granite. Last up to 15 years.

Key Features

• Maximum stain protection
• No-sheen natural look
• Allows moisture vapour transmission
• Does not alter the slip resistance of sealed surface
• Excellent weather resistance
• Now with built in Microban® – Cured Sealant is Mould & Mildew Resistant
• Solvent-based formula
• Penetrates into very dense materials
• Last up to 15 years

Suitable for use

As a natural look sealer for all natural stone surfaces (such as sandstone, slate, marble, limestone, granite, bluestone / basalt) unglazed tiles, porcelain tiles, clay pavers, concrete, brick, masonry, terracotta and grout. For interior and exterior use.

Limitations

• Do not allow sealer to come in contact with any non-recommended surface
• May slightly lighten or darken some stone surfaces
• Sealer will not prevent surface wear or etching from acids or caustic chemicals

Preparation

Surface should be dry, clean and free of waxes, sealers or finishes. New installations need to be dry 24 hours before application. Protect surrounding surfaces. Test product in an inconspicuous area to ensure desirable results.

The Stone, Tile or Grout must be dry prior to applying sealer – the following document explains in detail the definition of the term “dry” as it relates to sealer application. READ MORE

Procedure

• Always test a small area first to ensure satisfactory results
• Apply using a pump sprayer, paint pad applicator, lambswool applicator, sponge or brush.
• Allow it to penetrate for up to 5 minutes, if surface is drying within 5 minutes, apply more sealer to keep surface wet for up to 5 minutes.
• Wipe surface completely dry using clean, dry cotton, paper or microfiber towels after each application. Ensure no sealer is allowed to dry on the surface.
• Porous surfaces may require additional applications.
• Conduct a test to see if surface is completely sealed after 2 hours by applying drops of water on the surface. If it penetrates, an additional application is required.

Cleaning of equipment

Clean tools with mineral spirits after use

Drying Time

• Allow 30 minutes drying time between applications when conditions are 20° Celsius & 70% RH. If temperatures are lower or humidity higher then these times may be longer. If unsure about the specific job site temperatures and conditions please contact one of our technical advisors.
• Ready for surface traffic in minimum of 2 hours.
• Keep dry for a minimum of 12 hours.
• Achieves a full cure in minimum of 24 hours.