Demtech Elastofill Joint Filler 2 Litres Part A
Elastofill – Joint Filler
Cureflex Elastofill is a two part, hybrid polyurea, elastomeric joint filler. It is used to fill and protect joints in industrial concrete floors subjected to heavy, hard-wheeled vehicles.
It is also ideal for spalled joint repair, random joint filling and patching, etc. Cureflex Elastofill features a rapid cure time and is completely insensitive to moisture.
INTRODUCTION
Cureflex® Confix is a two part, ultra-low viscosity, polyurethane crack and spall repair system for concrete.
Its ultra-low viscosity allows it to penetrate deep into cracks for excellent adhesion and added strength. A rapid cure rate, allowing a return to service in just 1 hour, is an added bonus.
Cureflex® Elastofill is a two part, rapidcure polyurethane system for filling and protecting expansion joints.
Perfect for industrial concrete floors subject to heavy, hard-wheeled vehicles. It is also ideal for spalled joint repair, random joint filling and patching, etc.
Together, Cureflex® Confix and Elastofill are the perfect combo when applying Cureflex® TFC300. Prepare the surface with Confix, apply TFC300 then finish the job with Elastofill.
FEATURES & BENEFITS (Elastofill)
- Simple 1:1 mix ratio.
- Rapid-cure formulation.
- Easy to apply with a trowel.
- Strong adhesion properties.
- Fill concrete expansion joints
- Superior flexibility and elastomeric properties helps to prevent cracking.
- Use after TFC300 application.
TYPICAL AREAS OF USE
- Concrete slabs/surfaces.
- Fibrous compressed sheeting.
- Re-coating existing coatings.
- Residental garage floors.
- Alfrescos, paths and driveways.
- Industrial/commercial floors.
- Food processing plants/facilities.
- Medical centres/facitilties.
PREPARATION & APPLICATION
- Surface must be clean, dry and in sound condition. Remove all oil, dust, grease, loose particles and rust.
- Applications where Cureflex® TFC300 has been applied can occur after 48 hours to allow for sufficient curing.
- Mix/stir Part B thoroughly before use. This is to ensure no colour pigment is settled at the bottom of the container.
- Simply combine suitable, equal parts of Part A and Part B by volume (1:1 mix ratio) for the required area.
- Quickly mix using a small drill or paint stirrer for 10-15 seconds and apply within 3-5 minues.
No reviews found
