Flowcrete Flowprime ESD Conductive Black 5kg Kit Resin Based Conductive Primer

Flowprime ESD Conductive

Flowprime ESD Conductive is a 3-component, low-viscosity, resin-based conductive primer.

Uses

To be used prior to overcoating with Flowcrete's range of electrostatic dissipative (ESD) flooring systems. It provides electrical continuity under the ESD resin floor toppings and to earthing points.

Key Features

• Low Odour: This coating is formulated to be low in odour.
• Advanced Technology: Formulated using advanced resin technology to provide high-performance floor finishes.
• Ease of Use: The formulated resin provides excellent application properties.

Packaging

The product is supplied in full units as A+B+C packs.

• Base A: 0.86 kg
• Hardener B: 1.235 kg
• Pigment: 2.905 kg
• Total Kit Size: 5 kg

Product Synonym: Flowprime ESD Conductive 01

Coverage

Curing Times (at 20°C)

Application

• Application Temperature: 15–35°C recommended (minimum 10°C). Substrate temperature must exceed the dew point by 3°C during application and hardening.
• Pot Life: 20 minutes at 20°C. At higher temperatures the application time is shorter.
• Post-Application: Temperatures should not fall below 5°C in the 24 hours after application.

Substrate Requirements

Concrete or screed substrate should be a minimum of 25 N/mm², free from laitance, dust and other contamination. Substrate should be dry to 75% RH as per ASTM F2170 (AS1884:2012).

Mixing

Product is prepacked for optimum performance. Do not split pack. Stir Base A to re-disperse any settlement and empty into a clean container. Add Hardener B to the container and mix until uniform. Premix pigment pack and decant into the container. Mix thoroughly until uniform.

Storage

• Shelf Life: 12 months in unopened packs. If longer than 12 months, consult Flowcrete.
• Temperature: Store between 5°C and 35°C.
• Protection: Store inside, protected from frost, weather, moisture, direct sunlight and contamination.

Environment & Health

Follow the appropriate Occupational Health and Safety guidelines applicable to the location where the application is undertaken. For more information, please refer to the safety datasheets for the individual components.

Important Notes

• This system is not UV stable and will discolour unless otherwise stated.
• This system should have no contact with water for 5 days at 20°C or blooming may occur.
• Tools and equipment can be cleaned with MEK/Acetone/Xylene. Please refer to SDS when using solvents.
• Please refer to the appropriate product Technical Data Sheet. The PDS, TDS and SDS must be read in conjunction with one another.