Roberts R280 HT 15 Litres Vinyl Plank & Tile Adhesive

Roberts R280 HT Vinyl Plank & Tile Adhesive

ROBERTS R280 HT is an acrylic polymer, high-temperature hard set adhesive with a short open time and excellent adhesion. It is fibre-reinforced and highly shear-resistant with excellent plasticiser migration resistance and non-staining properties and provides resistance to temperature variations. It is for interior use only, is protected against biodegradation, withstands everyday cleaning practices, and is suitable for underfloor heating installations. It is ideal for bay windows, glass shop fronts, and other areas exposed to sunlight.

Recommended Use

PVC Vinyl Plank and Tile flooring, Vinyl Composite Tiles. It may also be used to install PVC commercial and domestic sheet vinyl if required. Not suitable for Rubber Floorcoverings.

Features & Benefits

• Installer Friendly
• High Shear Strength
• Green Star Compliant
• Building Green Credits
• Solvent Free
• Low VOC Emission
• Anti-microbial Formulation
• Low Odour
• Australian Made

Coverage

• V1 1.6mm x 1.6mm notched trowel: up to 5 square metres per litre
• V2 2.4mm x 2.4mm notched trowel: up to 3 square metres per litre

Application Data

Surface Preparation

Follow the recommendations of the current Australian Standard "Floor Coverings 1884-2021 Resilient Sheet & Tiles - Laying & Maintenance Practices." All surfaces should be dry, smooth, sound, clean and free of wax, grease, oil, previously applied adhesive, and other contaminants. Laitance on concrete substrates should be removed before using this adhesive.

ROBERTS R280 HT Adhesive may be applied onto concrete substrates with moisture content up to 85% relative humidity tested based on the In-Situ Probe method ASTM F2170. The alkalinity of the concrete must not be higher than pH 10. Subfloors must also be free of hydrostatic pressure.

Application

For the application of Vinyl, Vinyl Planks and Vinyl Composite Tiles, it is recommended that adhesive be spread with a 1.6mm x 1.6mm 'V1' notched trowel. For some Vinyl Planks with a textured or embossed backing, it is recommended to apply the adhesive with a 2.4mm x 2.4mm 'V2' notched trowel.

Apply only the amount of adhesive that can be covered within the short open time of the adhesive. Allow adhesive to have an open time - generally 5 minutes at 20°C before lowering the floorcoverings into the wet film of adhesive and roll to ensure transfer has occurred.

Do not allow heavy traffic for 24 hours.

Container Size

15-litre Plastic Container