Demtech Cureflex PCM17 2 Part Waterproof Membrane 25kg (15kg Powder + 10L Liquid)

Cureflex PCM17 2 Part Waterproof Membrane

Cureflex PCM17 is a fast drying 2 PART polymer cementitious waterproof membrane that is suitable for a wide range of waterproofing applications such as balconies, terraces, retaining walls, swimming pools and more!

It consists of Part A (10L liquid) and Part B (15kg dry powder).

CodeMark Certified under certificate number CM20308

Waterproof Coating

Cureflex – 2PART PCM-17 waterproof coating uses a new technique in "cross-collateralisation" in Powdered Polymer Technology (PPT), providing outstanding adhesion properties over a variety of building substrates such as concrete, masonry, Hebel panels, renders, compressed sheeting, cement sheet underlays, villa board, cement based compounds and all grade plaster board.

Cureflex 2PART PCM-17 also offers excellent surface adhesion properties for typical overlaid finishes such as screeds, renders and tile adhesives.

Introduction

Cureflex® PCM17 is a fast drying, two-part waterproof membrane that is suitable for a wide variety of waterproofing applications including:

• Applications over Insitu® shower bases, niches and balcony panels.
• Balconies, terraces and facades.
• Water features and swimming pools.
• Retaining walls and planter boxes.
• Water tanks and other water storage

With a 1:1.5 mix ratio of Part A (liquid) and Part B (powder), Cureflex® PCM17 waterproof coating is easy to use and apply. The formula utilises a new 'cross-collateralisation' technique in powdered polymer technology, offering excellent surface adhesion for overlaid finished such as screeds and tile adhesives.

Cureflex® PCM17 is a Class II membrane that complies with the AS/NZS 4858:2004 and exceeds the AS3740 requirements set out under 'Waterproofing wet areas in residential buildings' codes. Tested and approved by CSIRO Technical Assessment No. 349.

Preparation & Application

• All substrates must be clean and free from any contaminants before application.
• Suitable for applications on porous surfaces when primed using Cureflex® PG57.
• Suitable for applications on non-porous surfaces when primed using Cureflex® LS151.
• Requires a suitable bond breaker at all substrate junctions, usually applied on the first coat (Cureflex® Flexiban recommended).

Coverage & Curing

• 2 coats is recommended for general wet area applications (minimum coverage of 1.5L/m2).
• 3 coats is recommended for immersed/subterranean applications (minimum coverage of 2.0L/m2).
• Pot life of mixed membrane is approximately 1 hour (23°C).

Features & Benefits

• Solvent free formulation.
• Easy to apply with a brush or roller.
• Strong adhesion properties
• Leaves a durable, seamless finish.
• Suitable for internal and external use
• Exceptional flexibility and impressive elongation properties.
• Will not re-emulsify over time.
• Engineered to withstand ponding and permanent wet conditions.
• Holds its own weight over both horizontal and vertical substrates.

Suitable Materials

• Concrete and masonry
• Compressed sheeting.
• Cement sheet underlays.
• Cement based compounds
• All grades of plasterboard.
• Villaboard sheeting.