Stellmann Aqualine PU PRO Light Grey RAL 7035 P3 12kg Kit Non-Slip Floor Paint

Stellmann Aqualine PU PRO Light Grey RAL 7035 – P3 12kg Kit

Stellmann Aqualine PU PRO is a coloured, water-based, dual-component polyurethane floor coating system for interior and exterior concrete. It offers outstanding mechanical and chemical resistance, is UV-resistant, and is used on industrial halls, factories, stairs, cellars, commercial kitchens, passageways and corridors — as well as on interior and exterior concrete walls.

The Light Grey (RAL 7035) finish suits high-traffic industrial, commercial and public floors such as warehouses, factories, schools and public facilities.

This 12 kg kit is rated P3 under AS 4586.

⠀Features & Benefits

• Premium dual-component polyurethane — outstanding mechanical and chemical resistance
• Water-based, low odour and low VOC (less than 0.5% by weight)
• Semi-gloss finish; UV-resistant and non-yellowing — does not change colour like epoxies
• No separate primer needed on concrete — the first coat is diluted with water and acts as the primer
• Non-slip particles are mixed into the finish coat, so no broadcast aggregate is required
• Makes surfaces compliant with AS 4586 and AS 4663
• Dilutable with water — no thinners required; non-flammable and non-hazardous
• Chemical resistance tested against hydraulic and motor oil, petrol, diesel, salt water, cement water, xylene, bleach and paint thinner

⠀Technical Data

⠀Surface Preparation

• New concrete must cure for at least 28 days and be thoroughly dry (less than 3% building material moisture).
• The substrate must be structurally sound — compressive strength of at least 25 MPa and tensile strength of at least 1.5 N/mm². Repair all non-structural cracks and holes.
• Remove all loose material, dirt, oil, grease, old coatings, curing compounds, release agents and laitance by mechanical grinding, abrasive blasting, etching or another suitable method.
• The substrate must be sealed off from rising moisture. Apply a sample area in case of doubt.

⠀Application

• Stir Part A for 5 minutes, then mix Part A and Part B at 5 : 1 by weight — an electronic precision scale is mandatory.
• Prime coat: dilute the mixed coating with 15–20% water and apply. Apply the finish coat once dry, within 24 hours.
• Finish coat: dilute with 0–5% water, then mix in 3.0% of Stellmann Non-Slip P3 Particles by weight. Never add more than 3% — extra particles can reduce the slip rating.
• Apply evenly in sections with Stellmann PRO rollers, always finishing in the same direction. Do not roll back into curing areas.
• Do not apply a thick layer — a wet film above approx. 150 μm can cause CO₂ bubbles.

⠀Limitations

• Designed for concrete substrates. For tiles, use in combination with Stellmann Clear Primer; for any other substrate, contact Stellmann.
• Do not apply when rain threatens, or when relative humidity is (or is likely to go) above 80%.
• Not recommended for permanently immersed exposure, or where acid or alkali splash or spillage may occur.